Review with team on Connector Housing design during design review as per DFM and FMEA.
Perform Mold Design and conduct mold design review meeting based on our mold design guidelines/ check list and Mold Design FMEA.
Develop mold as per development schedule to support new product launch and ramp.
Work with Tool room on fabrication follow up and debug issues.
Work closely with Debug and Process Engineer on FOT and Qualification of Molds.
Coordinate with outside vendors for subcontracted molds for quotation, specification, review, follow up, FA closure and other technical issues.
Work with team in solving issues of housing and mold. Submit FA and work closely with QA Engineer and Product design to close housing FA.
Support Molding in terms of mold improvements and pre-production runs.
Analyze new products for Mold flow and warpage using CAE software.
Support Departmental Focal Points/Projects as required.
Value creation activities to drive new technology and methodology, GLSS and JDI savings to effectively reduce lead time, cost and quality to create long term value for the company.
Develop strategy of TTM/HMLV for low volume production with a shorter lead time
QN, QAP reduction by tooling improvement.
All activities & development must comply with laws & regulations to meet all safety & standard requirements.
Other duties as assigned by management
The Experience You Will Bring
Requirements:
Diploma / Degree in mechanical
At least 5 years working exp in Molding mold
Beware of fraud agents! do not pay money to get a job
MNCJobz.com will not be responsible for any payment made to a third-party. All Terms of Use are applicable.